It's not a secret that setting up a Netgear wireless router gifts users with a lag-free internet connection throughout the home. However, them being networking devices, it is quite common to run into issues with Netgear routers. A lot of users have complained about the Netgear router slow internet connection issue. If you are also experiencing the same problem, then walking through this post will help you resolve it. So, without any delay, let's find out the hacks that to speed up the router's internet connection.
After setting up the Netgear router using the 192.168.1.254 IP address, users need to relocate it to fill the dead zones in the house with a high-speed internet connection. However, a lot of them commit the mistake of selecting the wrong location for the router. If you have made the same mistake, consider relocating your Netgear router, and here's how to select an appropriate location:
After relocating your WiFi device, check if you're still facing the Netgear router slow internet connection issue. If you are, go to the next troubleshooting hack.
FYI, the Netgear router transmits the WiFi signals emitted by the modem. So, the source of communication between them has a great impact on the internet connection. Sometimes, the wireless connection is unstable due to which you face the Netgear router slow internet issue. That is why, consider using a wired source instead of a wireless one. Doing so will help both devices to communicate directly.
Just in case you've already opted for a wired connection, check that the Ethernet cable used to connect the Netgear router and modem is free of cuts. And, remember to make a finger-tight connection.
The firmware is permanent software programmed in the read-only memory of any networking device. And, your Netgear router is not different from those devices. Netgear rolls out a new firmware version from time to time that resolves the netgear router slow internet connection. Apart from that, it helps in securing your WiFi device from potential threats. So, keeping the firmware updated is like killing two birds with one stone.
Now, let us head over the instructions to update the firmware and eliminate the Netgear router slow internet issue. But, before that, consider running a ping test on your computer to verify the connection status between your Netgear router and computer. For this, you need to type Ping 192.168.1.1 in the Command Prompt and press Enter. If the test responds, then proceed to update the router's firmware. Here are the steps to carry out the Netgear router firmware update process.
That's how you can update your Netgear WiFi router.
Note: In case you are unable to update the firmware using 192.168.1.1 IP address, use 192.168.0.1.
Have you ever been a victim of a traffic jam? If the answer is yes, then you might know the struggle of getting out of it. Similar is the situation with your router's WiFi signals . You might also encounter the Netgear router slow internet issue if your WiFi device is operating on an overcrowded channel. In that case, change the wireless channel of your router.
To change the channel, log in to your router, and select any least crowded channel by navigating to Settings > Wireless > Region > Channel. Don't forget to click Apply.
This was all about how to fix the Netgear router slow internet issue. Just in case you are still not satisfied with your router's performance, restore it to the factory default mode, and reconfigure it by accessing the 10.0.0.1 IP address.
Consider contacting our well-versed technicians if the reset process also fails to resolve the problem for you. They're always ready to help you.
Disclaimer: 192-168-1-1ip.co is providing online technical support services independently. All the information published on the website is for informational purpose only. We do not claim any sponsorship or endorsement of any third-party company.